Khiro 10mm x 10mm Longboard Skateboard Bearing Spacer

Click photo to enlarge
(1 review)
Specifications
  • Width: 10mm (Very common; Fits most wheels)
  • Inner Diameter: 10mm (Only fits trucks with 10mm axles, Surf-Rodz, etc)
$5.95 USD
Description

Note: 10mm x 10mm Bearing Spacers fit 10mm Axles. Not common at all.

If you have been considering adding longboard skateboard bearing spacers to your longboard, you should read the following:

Adding spacers in between your bearings will align the bearing to the inner hub of your wheel. This will effectively reduce friction and movement inside the hub of the bearing. With spacers installed, the energy between turns is absorbed by the wheel and not the bearing itself, reducing impact and side load on the be bearing itself.

Reducing stress on your bearing components will help prevent your bearings from exploding or seizing up while riding your longboard. In addition to stress reduction, adding spacers will hold your wheels steady on your trucks during slides, preventing that annoying and sometimes dangerous choppiness experienced when sliding square-lipped wheels. Ultimately, you will have a bearing that will endure the demands of a downhill racer or freerider.

If you are doing any Racing, Downhill, Freeride, and especially Slides and hard carves, you will want to add Bearing Spacers to your Longboard Skateboard.

One pack is enough for 4 wheels

Khiro's Description

Khiro Bearing Spacers

Reviews

10mm ID Spacers, perfect
on 2018-09-24 Verified Purchase
These are perfect for Surf Rodz 10mm axles and a lot cheaper than other sources.